Gator Grater
Gutter Wizards Gator Grater
Gator Grater is an electric roll-forming machine that is the size of a typical gutter machine but weighs a bit more. Gator Grater can be taken to the job site or used for in-shop production. It uses downspout coil in 0.019", 0.024", or any typical gutter coil in copper, aluminum, or steel. Gator Grater can do fascia- or roof-mount covers. Switching between the two takes less than ten minutes. Gator Grater can make nine different no-clog gutter cover products. With Gator Grater, you can make solid cover with or without "Gatorback" ribs (speed bumps) two rows at a time; up to six total rows can be added. Gator Grater can also add six rows of "Gator Teeth" perforations.
This machine is territory-controlled based on area and population.
The following upgrades are available:
- Exit Rewinder Spools
- Spools with Uprights
- Entrance Feed Spools
- Fascia- and Roof-mount Combination Guillotine
- 14' Run-Out Table and Trip Switch
- Slitter Rewinder
Gator Grater is eight feet long, one foot wide, one foot high and weighs 1750 pounds (before upgrades).